Universal Laser Systems Laser Platform M-300 Průvodce řešením problémů stáhnout pdf (Strana 86)

8-2 Special Applications Guide

Place the stamp (on screen) where you want it to engrave in laser system. Avoid areas where

you have already engraved and cut out other stamps.

LASER ENGRAVING TABLE

10 2 3 4 5 6 7 8 9 10 11 12 13

SHEET OF RUBBER

STAMP MATERIAL

PREVIOUSLY

COMPLETED

STAMPS

REA WHERE NEW

STAMP WILL ENGRAVE

Place a sheet of rubber stamp material into the UPPER LEFT CORNER against the rulers, as

the following diagram illustrates, and be sure to properly focus on the material. Depending on

the wattage of your Laser Cartridge, set the Power, Speed, PPI, and DPI parameters in the

Printer Driver. If you are unsure about which settings to use, consult the Material Applications

Guide. Set the page size to Width to 11 inches and the Height to 8.5 inches. Click on Add

Shoulder but do not select Print Negative or Mirror Image. Select No Halftoning and make sure

Clipart Mode, Coated Metal Mode, and Curve Enhancement are turned OFF.

After making all driver selections, print the graphic to the laser system. Start engraving and

watch the stamp engrave and cut in the correct position on the rubber sheet. The background

area, since it is colored black is being engraved and the letters remain standing up. When the

engraving part is done, the stamp gets cut out along the red cut line due to the stronger settings

that were assigned in the driver for the color red.

Full Sheet Method

The second method is to create a full sheet of

rubber stamps and engrave them all at the same

time. First create a stamp as a positive image as

shown.

RED CUT LINE .001" THICK

BLACK FILLED GRAPHIC BLACK FILLED TEXT

Action Sports Equipment

100 Easy Street #117

Plainville, KS 99924

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 99 100

Žádné komentáře

Universal Laser Systems Laser Platform M-300 Průvodce řešením problémů Strana 86